DCM 010 | DC 20 TO 56 V
Applies to: The switch module is used to control DC powered devices with high capacities in control and switch cabinets. It is controlled via an external potential-free contact (thermostat or hygrostat), which is connected between terminal 3 and 4. It must be ensured that the external contact is suitable to switch the required signal current without any problems.
download> High DC switching capacity
> Variety of applications
> Wide DC voltage range
> Simple connection
The switch module is used to control DC powered devices with high capacities in control and switch cabinets. It is controlled via an external potential-free contact (thermostat or hygrostat), which is connected between terminal 3 and 4. It must be ensured that the external contact is suitable to switch the required signal current without any problems.
Switch Module DCM 010 (DC 20 to 56 V)
Art. No. | Max. switching capacity | Operating temperature |
---|---|---|
01010.0-00 | DC 15 A | -40 °C to +40 °C (-40 °F to +104 °F) |
01010.0-10 | DC 13 A | -40 °C to +50 °C (-40 °F to +122 °F) |
01010.0-20 | DC 11 A | -40 °C to +60 °C (-40 °F to +140 °F) |
Contact type | contact maker normally open (MOSFET) |
---|---|
Service life | > 100,000 cycles |
Operating voltage | DC 20 to 56 V |
Control contact – signal current | 3 mA at DC 20 V / 4.5 mA at DC 24 V 14 mA at DC 48 V / 17 mA at DC 56 V |
Connection | 6-pole terminal: stranded wire1 1.5 mm2 (AWG 16); max. 2.5 mm2 (AWG 12) |
Mounting | clip for 35mm DIN rail, EN 60715 |
Casing | plastic according to UL94 V-0, grey (bicolor) |
Dimensions | 93 x 53 x 44 mm |
Weight | approx. 65 g |
Fitting position | vertical |
Operating temperature | see article table below |
Storage temperature | -40 to +80 °C (-40 to +176 °F) |
Operating/Storage humidity | max. 90 % RH (non-condensing) |
Protection type | IP20 |
Approvals | UL File No. E342261, VDE, EAC |
Note | other versions on request |
1 When connecting with stranded wires, wire end ferrules must be used.