DA 084
Applies to: It has become increasingly important to provide a protected enclosure environment for valuable and crucial electrical and electronic components. In a tightly closed enclosure, pressure differentials can occur during extreme temperature variations, such as day/night operation. When this occurs, the risk of dust and humidity ingression into the control panel increases dramatically. The specially designed DA 084 vent plug permits a controlled change in pressure and can easily be installed in any enclosure. The vent plug is suitable for the use in enclo
download> High degree of protection (IP55)
> Easy to install
It has become increasingly important to provide a protected enclosure environment for valuable and crucial electrical and electronic components. In a tightly closed enclosure, pressure differentials can occur during extreme temperature variations, such as day/night operation. When this occurs, the risk of dust and humidity ingression into the control panel increases dramatically. The specially designed DA 084 vent plug permits a controlled change in pressure and can easily be installed in any enclosure. The vent plug is suitable for the use in enclosures and electrical cabinets in accordance with DIN EN 62208.
| Part No. | Protection type | 1Packing unit | Weight (approx.) |
|---|---|---|---|
| 08400.0-02-9002 | IP55 | 2 pieces | 62g (31g/piece) |
| Mounting | PG 29 thread with union nut |
|---|---|
| Torque | 5 Nm |
| Mounting position | vertical1 |
| Material | plastic, UL 94V-0, light grey weather proof and UV light resistant according to UL746C (f1) |
| Sealing | NBR gasket |
| Air Interface | Approx. 1.5 cm2 |
| Operating / Storage temperature | -49 to +158 °F (-45 to +70 °C) |
| Dimensions | ? 2.58" x 1.2” (? 65.5 x 30.5 mm) |
| Approvals | EAC |
1 Protection type is restricted to IP54 if mounting position is not vertical
Installation
A hole with a diameter of 1.46” (37 mm) is required for mounting. Make sure that the sealing gasket is placed on the outer side panel of the enclosure. For optimal pressure compensation, it is recommended to use two devices on opposite sides towards the top of the enclosures.
